Setup The Homeplugavs; For Twin Pack; For Single Pack - Aztech 500Mbps 4-Port HomePlugAV Ethernet Adaptor User Manual

Setup the HomePlugAVs

For Twin Pack

HomePlugAVs from a Twin Pack are preconfigured to have a common Private Network
Name unique for that pair. All you need to do is connect the HomePlugAVs to an Ethernet
device and then plug it to a power outlet.
To setup a pair of HomePlugAVs:
1. Plug one end of the Ethernet cable to your Ethernet device and then connect the
other end to HomePlugAV.
2. Connect the HomePlugAV to a power outlet.
3. Plug one end of the Ethernet cable to your other Ethernet device and then
connect the other end to HomePlugAV.
4. Connect the HomePlugAV to a power outlet.

For Single Pack

A HomePlugAV from a single pack uses a preconfigured Private Network Name. To add it
into an existing* network, all you need to do is to plug in your HomePlugAV into the
power socket then wait until the Power Line Activity LED switches ON.
To add a HomePlugAV to an existing network:
1. Plug your new HomePlugAV beside your existing HomePlugAV devices to easily
observe the LED behavior. Wait until the Power and PL-ACT LED to switch ON to
confirm that the connection has been established.
2. Once the connection has been established, unplug your new HomePlugAV device
then plug it into the location where you would like to use the device.
3. Plug one end of the Ethernet cable to your Ethernet device and then connect the
other end to your new HomePlugAV. Connect the HomePlugAV to into the power
outlet.
User Manual
Page 23 of 42