Table of Contents
Advertisement
O. SYSTEM'S TRIGGER CHECK
Press the transceiver
button first, within 3 seconds press
responds with one melody sound and all trigger's records will immediately be displayed
on the LCD screen.
P. DRIVER PAGING / LOST AND FOUND
only)
It is useful in the event that someone wants to page the driver of the parked motorcycle
or someone cannot find his LCD motorcycle remote transceiver.
When disarmed, press and hold the Valet switch for 2 seconds to page the driver. One
chirp sound shall be emitted from the motorcycle and the paging melody sound
continues sounding from your Remote LCD transceiver and "
the LCD screen.
Q. CHANNEL 3 TIMER CONTROL OUTPUT.
F
Press and hold the
button on transmitter for two seconds to remote control the channel 3 output.
Channel 3 is user-programmable timer output. You may program the built-in timer to send a ground signal
/ latch / latch with ignition / 30 seconds/ 60 seconds/ 90 seconds timer output.
Note1: Factory default setting at 1 second pulse grounded output.
Note2: Upon activating channel 3; the siren/horn will emit one chirp to indicate channel 3 is latched on or
emit two chirps to indicate channel 3 is latch off.
R. CHANNEL 4 TIMER CONTROL OUTPUT
F
Press the transmitter
and
Channel 4 is user-programmable timer output. You may program the built-in timer to send a momentary /
latch / latch with ignition / 30 seconds/ 60 seconds/ 90 seconds timer output.
Note1: Factory default setting is momentary output
Note2: Upon activating channel 4; the siren/horn will emit one chirp to indicate channel 4 is latched on or
emit two chirps to indicate channel 4 is latched off.
S. POWER ON MEMONRY:
This security system is equipped with circuitry that will allow the unit to remember its alarm state if the
power is lost and then reconnected.
T. POWER SAVE MODE FOR MOTORCYCLE'S POWER:
If the motorcycle is not driven within 12 hrs or the security system doesn't activate by remote control within
12hrs, the security system will automatically turn on power save mode. While in power save mode, the
security system uses approach "0" current to save the motorcycle's battery power.
When the system is in power save mode, all remote control and shock sensor function are bypassed,
however the ignition trigger / wire loop trigger / instant trigger / starter interrupt feature will remain
operational.
Exit the Power Save Mode:
Turn the ignition switch to on then off to exit the power save mode.
U. Forgotten blinker (left or right indicator):
When the Alarm is in the disarm mode and the ignition is ON (The engine is running) and a turn Indicator is
left ON. After 45 seconds, the unit will chirp once every 2 seconds. The Chirp will stop 2 seconds after
the Indicator is switched OFF.
MA-200 OP REV.A
(For two-way transceiver operation only)
(For two-way transceiver operation
buttons at the same time to active the Channel 4 function.
7
Oct/23/2006
(C)
button. It
" indication flashes on
Advertisement
Table of Contents
