Windage And Elevation; Cleaning The Eyepiece - ATN Aries 330 “Warrior” User Manual

The IR illuminator control buttons are located on its side. To switch the Digital IR illumina-
tor on/off press "+" and "-" buttons simultaneously. When the IR illuminator is switched
on you can see the green LED lit. By pushing the buttons "+" and "-" you may adjust the
IR brightness.
The IR beam is focusable to change the field of coverage. To change the beam width
slightly turn the IR lens.
You could change the IR control panel fitting your needs. The screw-tool included into the
set should be used for weakening the fixing screw located on the IR. Rotate the IR plac-
ing it at the most convenient position. Tighten the screw with the screw-tool to fix the new
position.
rangefinDer retiCle
A 6' target fits between the numbered baseline and
the main horizontal line. If the 6' target fits between the
2 and the right horizontal post of the main line the tar-
get is 200 yards away. If the same target fits between
the 5 and the right post of main line the target is 500
yards away. The same is with the 1, 3 and 4.
The target would be either 100, 300 and 400 yards
away. The vertical lines in chevron reticle are propor-
tioned to help in rangefinding and in making allowanc-
es for wind or movement.

WinDage anD eleVation

The vertical and horizontal adjustments for the Aries can be
achieved by turning the elevation and windage adjustment
mechanisms (remove dust caps first). Each click equals to
1/2 inch at 100 yards for the Aries 350 and 1/4 inch for the
Aries 330. When reaching the end of rotation do not use force.

Cleaning tHe eYePieCe

You may need to clean the eyepiece of the riflescope from time to time in order to guaran-
tee top performance. When you receive your riflescope you should check for dust on the
eyepiece of the unit.
First you will need to remove the eyepiece. To do that you will initially need to loosen the 2
set screws that can be found on the base. Then unscrew the eyepiece counter-clockwise
to remove it.
NOTE: You do not have to remove the set screws completely, they are very small and easy
to misplace.
CAUTION: Use only Photographic lens cleaning tissue on these surfaces. Be careful not
to scratch or smudge any of these surfaces. When using compressed air to blow dust
away, make sure to avoid inverting the can while spraying. This can cause frozen propel-
lant to exit the can, which can cause serious problems with the glass and phosphor screen.
If a 6' target fits
between these two
lines then the target lines then the target
is 500 yards away.
Elevation
If a 6' target fits
between these two
is 200 yards away.
Windage
4