Installation Of Helmet Mount To Helmet - ATN ODIN Operator's Manual

mount adapter that fits into a groove on the monocular. Make sure
the boss on the adapter fits into the groove on the monocular.
LATCH
FIGURE 2.3. HEADMOUNT/HELMET MOUNT ADAPTER INSTALLATION
2.1.6. INSTALLATION OF HELMET MOUNT
TO HELMET
(1) Remove the helmet mount from the carrying case. Refer to Fig-
ure 2.4. for helmet mount features.
(2) Press the release (Figure 2.5.) to remove the mount from the
helmet mount bracket.
(3) Make sure the strap is laced onto the helmet mount bracket as
shown in Figure 2.4.
(4) With catch (see Figure 2.4.) in forward most position, place the
strap over the top of the helmet center (see Figure 2.5.).
(5) Hook the rear bracket (see Figure 2.5.) on the center of the back
of the helmet and lay the strap with helmet mount bracket over the
top of the helmet.
(6) Hook the helmet mount bracket in the center of the front lip of the
helmet and hold it in place (see Figure 2.6.).
(7) With the buckle lever open, take up the slack in the strap using
the catch. Close the buckle lever.
2-6
DIOPTER AD-
JUSTMENT
BATTERY POLARITY
INDICATORS
EYE RELIEF
ADJUSTMENT
ON-OFF SWITCH