Installation Of The Quick Disconnect Helmet Mount Assembly - ATN PVS7-HPT User Manual

Nape
Straps
Loop the nape strap fastener tabs around the corners
of the chin strap and snap closed. After closure, the
snaps will be on the outside, away from your chin.
7. Disengage the nape strap latch on the left side of the nape strap.
8. Don the helmet.
9. Engage the nape strap at the nape strap latch. Tension the chin-
strap and nape strap for a secure and stable fit. The brow of the
helmet should be parallel with the ground.
2-7 INSTALLATION OF THE quICK DISCONNECT
HELMET MOuNT ASSEMBLY
1. Remove the helmet mount assembly from the carrying case.
Make sure the helmet mount is complete. Refer to Figure 2-7 for the
helmet mount components and features.
CAuTION
TO PREVENT POSSIBLE EQUIPMENT DAMAGE, REMOVE
BOTH THE GOGGLES AND THE MOUNT ASSEMBLY FROM
THE HELMET WHEN NOT REQUIRED FOR IMMEDIATE USE.
THE CLIP/STRAP ASSEMBLY CAN REMAIN IN PLACE ON THE
HELMET.
2-20
Nape Strap Fastener Tabs
Figure 2-9. Nape Strap Installation
Chin Strap