Preparation; Preparation For Use - ATN ODIN Operator's Manual

2.1. PREPARATIONS

2.1.1. PREPARATION FOR USE

This chapter contains the information necessary to prepare the
scope for operation. This includes unpacking, examination for
damage, and battery installation.
A. UNPACKING
The following steps must be accomplished prior to each mission
where the sight is used.
1. Open carrying case, remove the scope and check contents
for completeness.
2. Inspect the scope for obvious evidence of damage to opti-
cal surfaces, body, eyecups, operation buttons, etc. Ensure
that all optical surfaces are clean and ready for use. Clean
with lens paper.
B. ATTACHMENT OF NECK LANYARD
To prevent damage due to dropping the scope, use the neck lan-
yard included with your equipment.
C. INSTALLATION OF BATTERY
WARNING
The lithium battery contains sulphur dioxide gas under pres-
sure.
Do not heat, puncture, disassemble, short circuit, attempt to
recharge or otherwise tamper with the batteries.
Turn off equipment if battery compartment becomes unduly
hot. If possible, wait until the batteries have cooled before
removing them.
If you inhale sulphur dioxide, seek medical attention.
The Odin will operate with one CR123A Lithium battery type.
CAUTION
Make certain the operation switch is in the OFF position before
installing batteries.
2-2