Planet ICA-550W User Manual page 46

Secondary Port
RTSP Port
RTP Data Port
Max RTP Data
Packet
UPnP
Enable Discovery
Enable Traversal
This sets the port number for HTTP (Web) connections to the
Camera, whether for administration or viewing video.
•
If enabled, you can connect using either port 80 or the
Secondary port. You must enter the Secondary port number
(between 1024 to 65535) in the field provided.
Note that when using a port number which is not 80, you must
specify the port number in the URL. For example, if the Camera's
IP address was 192.168.1.100 and the Secondary port was 1024,
you would specify the URL for the Camera as follows:
http://192.168.1.100:1024
The RTSP (Real Time Streaming Protocol), a standard for
connected client(s) to control streaming data (MPEG-4) over the
World Wide Web.
If desired to change, enter the RTSP Port number (between 1024 to
65535) in the field provided. The default RTSP Port is 554.
The RTP (Real-Time Transport Protocol), an Internet protocol used
for transmitting a single real-time multimedia data such as audio
and video to a select group of connected clients. The RTSP uses
RTP to format packets of multimedia content.
The Internet Camera's data Port number has been pre-configured
and can be used for multi casting, and does not normally need to be
re-configured. If the port number does need to be changed, please
contact your network administrator.
If desired to change, enter the data Port number (between 1024 to
65534) in the field provided.
If desired to change, enter the Max RTP Data Packet Length
(between 400 to 1400 bytes) in the field provided.
If enabled, the Network Camera will broadcast its availability
through UPnP. UPnP compatible systems such as Windows XP will
then be able to detect the presence of the Network Camera.
If enabled, HTTP connections (from your Web Browser or the
Viewer and Recorder utility) can use secondary port instead of port
80 (the standard HTTP port) to access the camera.
40