Pioneer XW-SMA1 Operating Instructions Manual page 19

Connect to network
A: Connections for wireless LAN using WPS-
PBC function
1 Confirm that the AC adapter and LAN cable
are not connected to the unit.
LAN(10/100) iPod/iPhone/iPad
2 Connect the AC adapter, and press
 standby/on button.
The on indicator will flash blue. Wait for about 30 to 40
seconds.
DC IN AUX IN
3 When the on indicator stops flashing, press
the rear-panel network setup/wireless direct
button.
The network indicator will change from flashing red to
flashing purple.
4 Within 2 minutes, press the router's WPS
button.
For information regarding router operation, consult the
router's Operating Instructions.
WPS
WPS
5
performed automatically, and when the
connection is complete, the unit's indicator will
briefly change to flashing red, then light steadily
blue.
The indicator will flash blue when the signal is weak.
DC IN AUX IN
B: Wired connection to a router with DHCP
server
1
before performing the connection between
router and this unit.
Use a LAN cable to connect this unit and your router.
6
2
 standby/on button.
network setup
wireless direct
The on indicator will flash blue. Wait for about 30 to 40
DC IN AUX IN seconds.
3
when the power is fully turned on, the network
indicator will light blue.
The network connection settings will be
Disconnect the power cord from AC power
LAN(10/100) iPod/iPhone/iPad
LAN
3 2 1 WAN
Connect the AC adapter, and press
DC IN AUX IN
The on indicator's flashing will stop, and
blue
04
blue
DC IN AUX IN
6
19
En