Initial Settings; Adjusting Initial Settings; Setting The Clock; Setting The Fm Tuning Step - Pioneer DVH-P6050UB Operational Manual

Section
02 Operating this unit

Initial Settings

Adjusting initial settings

Using the initial settings, you can customize
various system settings to achieve optimal per-
formance from this unit.
1 Press SOURCE and hold until the unit
turns off.
2 Press MULTI-CONTROL and hold until
the initial setting menu appears in the dis-
play.
3 Turn MULTI-CONTROL to select one of
the initial settings.
Turn MULTI-CONTROL to switch between the
functions in the following order.
CLOCK (clock)—FM STEP (FM tuning step)—
AM STEP (AM tuning step)—WARNING
(warning tone)—AUX1 (auxiliary input1)—
AUX2 (auxiliary input2)—VIDEO IN (AV input
setting)—CAMERA (rear view camera setting)
—REAR SP (rear output and subwoofer con-
troller)—EVERSCROLL (ever scroll)—
TV SIGNAL (TV signal setting)—D.ATT (digital
attenuation)—AUDIO RESET (audio reset)
Use the following instructions to operate each
particular setting.
# You can also select the function by pressing
FUNCTION on the remote control.
# To cancel initial settings, press BAND.
# When you select CAMERA (rear view camera)
in VIDEO IN, you can select CAMERA (rear view
camera setting).
# When the multi-channel processor (e.g., DEQ-
P7650) is connected to this unit, you can operate
D.ATT and AUDIO RESET instead of REAR SP.

Setting the clock

Use these instructions to set the clock.
48
En
1 Use MULTI-CONTROL to select CLOCK.
Refer to Adjusting initial settings on this page.
2 Push MULTI-CONTROL left or right to
select the segment of the clock display you
wish to set.
Pushing MULTI-CONTROL left or right will se-
lect one segment of the clock display:
Hour—Minute
As you select segments of the clock display,
the selected segment blinks.
3 Push MULTI-CONTROL up or down to
put a clock right.
Note
You can match the clock to a time signal by
pressing MULTI-CONTROL.
! If 00 to 29, the minutes are rounded down.
(e.g., 10:18 becomes 10:00.)
! If 30 to 59, the minutes are rounded up. (e.g.,
10:36 becomes 11:00.)

Setting the FM tuning step

The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
! If seek tuning is performed in 50 kHz steps,
stations may be tuned in imprecisely. Tune
in the stations with manual tuning or use
seek tuning again.
1 Use MULTI-CONTROL to select FM STEP.
Refer to Adjusting initial settings on this page.
2 Press MULTI-CONTROL to select the FM
tuning step.
Pressing MULTI-CONTROL repeatedly will
switch the FM tuning step between 50 kHz
and 100 kHz. The selected FM tuning step will
appear in the display.