Using The High Pass Filter; Boosting The Bass - Pioneer DVH-P6050UB Operational Manual

Operating this unit
2 Press MULTI-CONTROL to turn subwoo-
fer output on.
NORMAL appears in the display. Subwoofer
output is now on.
# If the subwoofer output phase has been set to
the reverse, REV will be displayed.
# To turn subwoofer output off, press
MULTI-CONTROL again.
3 Push MULTI-CONTROL left or right to
select the phase of subwoofer output.
Push MULTI-CONTROL left to select reverse
phase and REV appears in the display. Push
MULTI-CONTROL right to select normal phase
and NORMAL appears in the display.
Note
You can also switch to this setting mode in the
menu that appears by using MULTI-CONTROL.
Adjusting subwoofer settings
When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
! When the subwoofer output is on, you can
select SUB W2.
1 Press SW to select SUB W2.
Press SW repeatedly to switch between the
subwoofer setting modes in the following
order.
SUB W1 (subwoofer on/off setting) setting
mode—SUB W2 (subwoofer setting) setting
mode
2 Push MULTI-CONTROL left or right to
select cut-off frequency.
Each time MULTI-CONTROL is pushed left or
right, cut-off frequencies are selected in the
following order:
50—63—80—100—125
3 Push MULTI-CONTROL up or down to
adjust the output level of the subwoofer.
+6 to –24 is displayed as the level is increased
or decreased.
Note
You can also switch to this setting mode in the
menu that appears by using MULTI-CONTROL.

Using the high pass filter

When you do not want low sounds from the
subwoofer output frequency range to play
from the front or rear speakers, turn on the
HPF (high pass filter). Only frequencies higher
than those in the selected range are output
from the front or rear speakers.
1 Use MULTI-CONTROL to select HPF.
Refer to Introduction of audio adjustments on
page 38.
2 Press MULTI-CONTROL to turn high
pass filter on.
80HZ appears in the display. High pass filter is
now on.
# If the high pass filter has been previously ad-
justed, the frequency of that previously selected
will be displayed instead of 80HZ.
# To turn high pass filter off, press
MULTI-CONTROL again.
3 Push MULTI-CONTROL left or right to
select cut-off frequency.
Each time MULTI-CONTROL is pushed left or
right, cut-off frequencies are selected in the
following order:
50HZ—63HZ—80HZ—100HZ—125HZ

Boosting the bass

Bass boost function boosts the bass level of
sound.
Section
02
41
En