Using Nonfading Output; Adjusting Nonfading Output Level; Using The High Pass Filter; Adjusting Source Levels - Pioneer Super Tuner III D+ DEH-P7750MP Operation Manual

Section
10 Audio Adjustments
Only frequencies lower than those in the se-
lected range are outputted from the subwoo-
fer.
3 Push Multi-Control up or down to ad-
just the output level of the subwoofer.
Each pushing Multi-Control up or down in-
creases or decreases the level of the subwoo-
fer. +6  6 is displayed as the level is
increased or decreased.

Using nonfading output

When the nonfading output setting is on, the
audio signal does not pass through this units
low pass filter (for the subwoofer), but is out-
putted through the RCA output.
1 Use Multi-Control to select nonfading
output on/off setting.
ON appears in the display.
# When the subwoofer controller setting is only
Preout :FULL, you can switch to the nonfading
output on/off setting. (Refer to page 50.)
2 Press Multi-Control to turn nonfading
output on.
ON appears in the display. Nonfading output
is now on.
# To turn nonfading output off, press
Multi-Control again.

Adjusting nonfading output level

When the nonfading output is on, you can ad-
just the level of nonfading output.
1 Use Multi-Control to select nonfading
output setting.
0 appears in the display.
46
En
All manuals and user guides at all-guides.com
2 Push Multi-Control up or down to ad-
just the nonfading output level.
Each pushing Multi-Control up or down in-
creases or decreases the level of the nonfad-
ing output. +6  6 is displayed as the level is
increased or decreased.

Using the high pass filter

When you do not want low sounds from the
subwoofer output frequency range to play
from the front or rear speakers, turn on the
HPF (high pass filter). Only frequencies higher
than those in the selected range are outputted
from the front or rear speakers.
1 Use Multi-Control to select HPF.
HPF appears in the display.
2 Press Multi-Control to turn high pass fil-
ter on.
80Hz appears in the display. High pass filter is
now on.
# To turn high pass filter off, press
Multi-Control again.
3 Push Multi-Control left or right to select
cut-off frequency.
Each pushing Multi-Control left or right se-
lects cut-off frequencies in the following order:
50Hz80Hz125Hz
Only frequencies higher than those in the se-
lected range are outputted from the front or
rear speakers.

Adjusting source levels

SLA (source level adjustment) lets you adjust
the volume level of each source to prevent ra-
dical changes in volume when switching be-
tween sources.