Step1: Display Installation - Wacom DTU-2231 Quick Start Manual

STEP1: DISPLAY INSTALLATION

Install the interactive pen display as a monitor on your system.
Important: Do not connect the USB data cable until instructed to do so. Never connect or disconnect
the video or power cables while your computer or pen display are powered on. This can
damage the display or video card.
1. Turn off your computer.
Video card
Computer
Caution
Make sure your video card has a DVI or VGA connector, and that you correctly set the DVI/VGA switch for the
video connector you are using.
Only use a power adapter specified for use with your pen display; use of an improper power adapter may
damage the unit.
Make sure the display refresh rate does not exceed the maximum vertical frequency that your pen display can
support. See the product specifications for details.
6. Turn on the pen display. The power LED will light orange.
2. DVI/VGA switch
Or
3. DVI-D to DVI-I cable
or VGA to DVI-I cable
To AC outlet
5. Power adapter
Analog (VGA)
Digital (DVI)
4. DC input
Use the DVI-I port to
OUT
connect a second device,
such as a projector or monitor.
Fully install the hardware and
software before connecting
another device.
DVI-I
IN
English
3