The DTF-720AB Display
The Auto-Adjust Function
In order to ensure optimal display image quality, this product utilizes the Auto-Adjust
function. When the Auto-Adjust function is operating, it may take a short time before the
screen displays properly. The settings initiated by Auto-Adjust are saved in the display.
If the Auto-Adjust function is operating, the horizontal and vertical positions as well as the phase
and pitch of the display are adjusted automatically when the display mode is received. The Auto-
Adjust function becomes operational when the horizontal frequency is in the 30-80KHz and the
vertical frequency is in the 50-75Hz range.
When the Auto-Adjust function is operating, only the power switch is operational.
Pen calibration may be necessary after adjusting screen position. ( → P13)
The DTF-720AB Power Saving Function
This product is in compliance with VESA and ENERGY STAR power-saving guidelines.
When connected to a Display Power Management (DPMS)-compatible computer and
graphics board, the power savings indicated below are automatically realized during
times of non-operation.
Computer Activity
Turned On (Normal operation mode) Yes
Stand-by Mode
Suspend Mode
Off Mode
* Depending on the specifi cations and settings of your computer and video card, when in
standby and suspend modes, the power lamp may only light up orange.
12
T F 7 2 0 A B ( E ) . i n d b 1 2
Horizontal
Vertical
Synchronizing
Synchronizing
Signal
Signal
Yes
No
Yes
Yes
No
No
No
Picture
Power
Power Lamp
Signal
Consumption
Yes
37W
Blue
No
Less than 2W Orange/Blue*
No
Less than 2W Orange/Blue*
No
Less than 1W Orange
9 . 1 . 1 5
: 3 5 : 1 9 P M