Alarms; Overview - Honeywell ARENA User Manual

ARENA / RANGER
Multi Site Alarming Support
Manual Alarm Clearing
Determine Alarm Reason
Link to the Alarm Destination
Alarm Display
EN2Z-0906GE51 R0708
4. In the Print dialog box, select the printer and desired options and click Print.
On a supervisor ARENA, alarms can be collected centrally from all sites.
The user can "artificially" create a going alarm for a selected coming alarm. If the
user knows for sure that an alarm is gone, he can clear it.
You can navigate directly to the alarm source.
Support of different dialling destinations
It is sufficient that a remote site without ARENA dials to one destination central, a
so-called "relay central".
Support of alarm routing for application and system alarms (=point alarms)
The remote site routes system alarms and application alarms to different
destinations. The selection of application alarms is done based on the datapoint
name (=user address). This feature is supported indirectly through a relay ARENA
using the alarm forwarding feature of ARENA. This means: A remote site always
dials out to the same ARENA, regardless of the alarm cause. This ARENA acts as
relay for further alarm segregation.
Alarms can be seen on any level (Site, System, Plant, etc.). Depending on the level,
the alarm list display differs in the number and kind of columns (alarm properties).
Depending on the selected level, an alarm can feature at maximum the following
properties displayed as columns in the list:
72
USER GUIDE

ALARMS

Overview