Honeywell ARENA User Manual page 56

ARENA / RANGER
Monitoring (Home) Site (A)
must match user name / password
of incoming connection of site B
Prevent Supervisor ARENA
from ACCESS and VIEWING
through Remote ARENA
must match user name / password
of outgoing connection of site A
Remote Site (B)
EN2Z-0906GE51 R0708
Dial-up connections are typically used to connect to an ISP (internet service
provider) when the mail server is not reachable via LAN.
NOTES:
– Yahoo cannot be used as ISP because there are issues on the provider
– ARENA shows all dial-up connections on your PC here, except the ones
ATTENTION!
When selecting an existing dial-up connection, make sure that the modem
connection is set up in a way that it does not attempt to retry after the phone
line drops, because this conflicts with the retry attempts of ARENA. You can
check this by selecting Connect to / Show all connections from the Windows
Start menu. Then open the properties of the connection.
e. Continue with step
6. Create Remote Site through ARENA via Modem
The following descriptions refer to an Example of a typical scenario of a Supervisor
ARENA – Remote ARENA configuration via Modem as shown in the graphic above.
Supervisor ARENA
SITE Configuration
Name: represents site B
Outgoing Connection
User Name / Password:
MAINTENANCE CALLS
SITE Configuration
Name: represents site A
Incoming Connection
User Name / Password:
Remote ARENA
Fig. 17. System Diagram: Remote Through ARENA via Modem
CAUTION
Do not switch off or disconnect a modem when operating a modem-connected site.
This causes a malfunction and as a result the need to reboot the PC.
TIP:
Connect PC and modem to the same power supply. In case of a general power
failure, PC and modem will be restarted simultaneously.
7. If not already done, select ´Modem` in Connect Through under Outgoing
connection to remote site and do the following:
side concerning external email access. Use an alternative ISP.
used to connect to remote sites. ARENA will also allow creating new
Dial-up connections to ISPs, which is the recommended way for alarm
forwarding. You can choose an existing dial-up connection to an ISP.
1 0.
1
Site A
SITE Configuration
Name: represents site B
Incoming Connection
User Name / Password:
must match user name / password
of outgoing connection of site B
ALARMS
Modem
SITE Configuration
Name: represents site A
Outgoing Connection
User Name / Password:
must match user name / password
of incoming connection of site A
PANTHER / TIGER
Site B
SERVAL SERVAL
56
*
4
PANTHER / TIGER
SERVAL SERVAL SERVAL
USER GUIDE
LON Bus