Getting Connected; Remote And Power Cable - VocoPro DA-3808 PRO Owner's Manual

Getting Connected

About the Remote Control
• The area between the remote control and the main
unit must be clear of large obstacles.
• Do not expose the remote control sensor to strong
lighting, especially an inverter type fluorescent
lamp as this may cause the remote control to not
function properly.
Installing Batteries in the Remote Control
1. Turn the remote control over and slide the battery
compartment cover off towards the direction of the
arrow.
2. Insert the AA batteries, positioning them according
to the polarity (+, --) markings on the inside of the
battery compartment.
3. Close the battery compartment cover.
Battery Replacement
If you find that the distance between the remote
control and the main unit must be shorter in order to
use the remote control, this means that the batteries
are low and must be changed. Replace both
batteries with new ones.
Battery Notes:
• Use AA batteries.
• Be sure the polarities (+, -) are correct. (See the
illustration inside the battery compartment).
• Remove the batteries when not using the remote
control for an extended period of time.
• If batteries leak, dispose of them immediately.
Avoid skin, clothing and any other contact with the
leaked material. Clean the battery compartment
thoroughly before installing new batteries.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) with
rechargeable (nickel-cadmium) batteries.
Connecting the Power Cable
Plug the supplied AC power cable into the AC inlet
after all other connections are complete and then
plug the AC power cable to an AC wall outlet.
CAUTION
Use the supplied AC cable. Do not use other AC
power cables as doing so may result in fire hazard or
electrical shock.
Image shown is a generic model for reference.
7