Speakers - VocoPro DA-3808 PRO Owner's Manual

Getting Connected
Connecting Speakers
The Speaker Terminals are located on the rear panel.
There are two STEREO terminals. Be sure to connect the
left channel (L), right channel (R), "+" (red) and "--" (black)
properly.
���������� ���� �����
WARNING: TO REDUCE THE RISK
����� ��� ������� ���
OF FIRE OR ELECTRIC SHOCK, DO
NOT EXPOSE THIS EQUIPMENT TO
���������������� �������
RAIN OR MOISTURE
����� ������������ ����
������ ���
CAUTION: TO PREVENT ELECTRIC
SHOCK, DO NOT REMOVE COVER
SCREWS. NO USER-SERVICEABLE
PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
�� �������
��������
110V
220V
THE POWER
SUPPLY CORD
SHOULD BE
DISCONNECTED
BEFORE
������� ������
CHANGING THE
��������� ��� ����
VOLTAGE
����� � ������ SELECTOR
• Before connecting the speakers, make sure that the DA-
3808 PRO is disconnected from the power source.
• Do not let the bare speaker wires touch each other or
another metal part of this unit. This could damage the DA-
3808 PRO and/or the speakers.
Determining the proper way to connect the speaker
cables:
The speaker cable is a pair of insulated cables running side
by side. One cable is colored or shaped differently, perhaps
with a stripe, groove or ridges.
1. Connect one end of the striped (grooved, ridged, etc.)
cable to the "+" (red) terminal on the rear panel of the
DA-3808 PRO.
2. Connect the other end of the striped (grooved, ridged,
etc.) cable to the "+" (red) terminal on the speaker.
3. Connect one end of the "plain" (NO stripes, grooves,
ridges, etc.) cable to the "--" (black) terminal on the rear
panel of the DA-3808 PRO.
4. Connect the other end of the "plain" (NO stripes, grooves,
ridges, etc.) cable to the "--" (black) terminal on the
speaker
������� ���
����������
����
CAUTION: TO
REDUCE THE
RISK OF FIRE,
REPLACE
ONLY WITH
SAME TYPE
FUSE
�������
�����
�� �����
����������
�������
������� �����
Preparing the Speaker Cable
You can either used an exposed speaker wire or Banana
Plug speaker cable.
Exposed Speaker Wire
1. Remove approximately 3/8" (10mm) of insulation.
����
2. Twist the exposed wires together to prevent short
circuits.
3. Loosen the knob on the speaker terminal.
4. Insert the bare wire.
5. Tighten the knob until the wire is secure.
�
������ ���������
Using Banana Connectors
1. Plug the Banana connectors into the speakers, ensuring
the black and red connectors are aligned properly.
2. Plug the other ends of the cables into the DA-3808
PRO's speaker output, ensuring the black and red
connectors are aligned properly.
8
� �