Table of Contents
Advertisement
Segment Replacement (for
wheel cfm 17,500 and
higher)
Installation Procedure for
Inner Segments
Note: Install and remove all
segments at location indicated by
arrow in Figure 12.
1. Rotate the wheel clockwise to
align the center of a spoke
opening with the pulley. Secure
pulley and belt with vise grip to
prevent wheel rotation (see
Figure 13).
2. Remove 1/4-20 flat head screw
from segment nose bracket.
3. Center and rest segment on lower
spoke. Slide segment on spoke
until nose bracket contacts stop in
hub plate. Insert screw and
tighten until screw is firmly
seated (see Figure 14).
4. Holding wheel to prevent
rotation, remove vise grip. Rotate
wheel clockwise to install
segments in the order shown in
Figure 12.
5. Secure pulley. Repeat steps 2
through 4 until all inner segments
are installed.
Installation Procedure for
Outer Segments
1. Align segment opening with
pulley. Secure pulley and belt
with vise grip to prevent rotation
(see Figure 13).
2. Rotate outer segment retainer
latch, located at end of spokes, 90
degrees from rim and remove
two forked outer segment
retainers.
3. Install outer segment by starting
lower end in position and
pressing straight in against four
14
Routine Maintenance
corners. Sharp rap with heel of
hand will assist entry when
needed (see Figure 15). Note:
Only reinstall segment retainer
between adjacent installed
segments.
4. Rotate both retainer latches to
closed position to prevent
interference with bearing support
beam while rotating wheel by
hand.
5. Repeat steps 1 through 4 in the
order shown in Figure 12until all
outer segments are in place.
Make certain all retainer latches
are latched in place under catch
.
Figure 14. Slide segment on spoke
until contacts stop in hub plate.
Figure 15. Install outer segment by
starting lower end in position and
pressing straight in
Cleaning the Energy
Wheel Motor
WARNING
Hazardous Voltage!
Disconnect all electric power,
including remote disconnects before
servicing. Follow proper lockout/
tagout procedures to ensure the
power can not be inadvertently
energized. Failure to disconnect
power before servicing could result
in death or serious injury.
Disconnect all electrical power, then
use a vacuum cleaner and brush to
remove accumulated material from
the energy wheel motor. The use of
spray aerosol cleaners is not
recommended. Examine the motor
monthly for debris accumulation.
CLCH-SVX02C-EN
Advertisement
Table of Contents
