Diagnostic Reset - Trane Tracer CH.530 RLC-SVU01B-E4 Owner's Manual

EasyView Interface

Diagnostic Reset

If the machine is in a
diagnostic condition
(LED is flashing), a
transition from Stop to Auto will
reset the diagnostic. If the machine is
in the Stop State (Auto LED off),
depressing the AUTO key will reset
all diagnostics. If the machine is in
the Auto State (Auto LED on), it must
be put in the Stop state and
sequenced back to Auto in order to
reset.
SI vs. English (I-P)
The Leaving-Water Set Point and the
Leaving-Water Temperature are
displayed in either SI or English (I-P)
units as determined by the
appropriate setting within the
processor. A right-justified C or F will
indicate SI or English.
Power-Up Test
On power-up, a means to test the
display and annunciators is required.
To demonstrate that all segments
and LEDs can be lighted, EasyView
will light all segments and
annunciators for approximately 2
seconds. To demonstrate that no
elements are stuck on, EasyView will
turn off all segments and
annunciators for approximately 2
seconds. Normal operation will
follow.
RLC-SVU01B-E4
8