Getting Started; Unpack And Inspect The Components - Trane VariTrac VAV-SVN03A-EN Installation Manual

Getting Started

Familiarize yourself with the system components and preview the
installation procedures before installing and configuring the VariTrac
system.
Installation and configuring procedures appear in suggested order of
performance:

• Unpack and inspect the components

• Mount the wiring base
• Wire AC power
• Binary input wiring
• Output wiring
• Install communicating sensor/bypass damper control
• Install bypass damper(s) and connect to communicating sensor/bypass
control assembly
• Install VariTrac dampers
• Connect UCM wiring
• Set UCM DIP switches
• Install slaved dampers (if used)
• Install zone temperature sensors
• Communication link wiring
• Mount main module
• Install operator display (optional)
• Connecting modem devices
IMPORTANT
The CCP is designed to work with UCM III and IV VariTrac damper and
VariTrane VAV controllers produced beginning January 1995. If any other
dampers are used (especially on a retrofit job), please consult the factory
to confirm VariTrac Central Control Panel compatibility prior to installa-
tion.
Unpack and Inspect the Components
Inspect components for damage. Match each component to the packing list
to ensure that nothing was lost during shipment. Make sure that the litera-
ture is not lost or discarded with the packing material. Visually inspect the
central control panel for damage. All components are thoroughly inspected
before leaving the factory. Any claims for damage incurred in shipping must
be filed with the carrier.
VAV-SVN03A-EN 13