The Rear Panel - TP-Link TL-WR841N User Manual

Note:
After a device is successfully added to the network by QSS function, the QSS LED will keep on for
about 5 minutes and then turn off.

1.4.2 The Rear Panel

The following parts are located on the rear panel (View from left to right).
ON/OFF: The switch for the power.
POWER: The Power socket is where you will connect the power adapter. Please use the
power adapter provided with this TL-WR841N/TL-WR841ND 300Mbps Wireless N Router.
WAN: This WAN port is where you will connect the DSL/cable Modem, or Ethernet.
4,3,2,1 (LAN): These ports (4,3,2,1) connect the Router to the local PC(s).
RESET:
There are two ways to reset to the Router's factory defaults:
1) Use the Factory Defaults function on "System Tools → Factory Defaults" page in the
Router's Web-based Utility.
2) Use the Factory Default RESET button: With the Router powered on, use a pin to press
and hold the RESET button (about 5 seconds) until the SYS LED becomes quick-flash
from slow-flash. And then release the button and wait the Router to reboot to its factory
default settings.
Wireless antenna: To receive and transmit the wireless data.
TL-WR841N/TL-WR841ND
Figure 1-2 Rear Panel sketch
- 6 -
300Mbps Wireless N Router