Air Filter - Echo CS-400 Instruction Manual

Spark plug
Cleaner cover knob
Spark plug
Cylinder cover
Cylinder cover
0.65 mm (0.026 in.)
0.65 mm (0.026 in.)
Oil filter
Oil tank cap
NOTE
Federal EPA regulations require all model year
2012 and later gasoline powered engines produced
for sale in the United States to be equipped with a
special low permeation fuel supply hose between
the carburetor and fuel tank. when servicing model
year 2012 and later equipment, only fuel supply
hoses certified by EPA can be used to replace
the original equipment supply hose. Fines up to
$37,500 may be enforced for using an un-certified
replacement part.
CS-400
Air cleaner cover
Air filter cover

Air filter

Air filter cover
Air filter
Fuel filter
Fuel tank cap
• Check before every use.
• Loosen cleaner cover knob and remove air
cleaner cover and filter.
AIR FILTER
• Brush off dust lightly, or clean with compressed
air, or replace the air filter.
• Check before every use.
• Close choke ( ).
• Reinstall air filter and cover.
• Loosen cleaner cover knob and remove air cleaner
cover and filter.
CHECK FUEL SYSTEM
• Brush off dust lightly, or clean with compressed air, or
replace the air filter.
• Check before every use.
• Reinstall air filter and cover.
• After refueling, make sure fuel does not leak
from around fuel pipe, fuel grommet or fuel tank
cap. CHECK FUEL SYSTEM
• In case of fuel leakage there is a danger of fire.
• Check before every use.
Stop using the machine immediately and request
• After refueling, make sure fuel does not leak from
your dealer to inspect or replace.
around fuel pipe, fuel grommet or fuel tank cap.
• In case of fuel leakage there is a danger of fire. Stop
using the machine immediately and request your
SPARK PLUG
dealer to inspect or replace.
• Check periodically.
• The standard spark gap is 0.65 mm
SPARK PLUG
(0.026 in.).
• Check periodically.
• Correct the spark gap if it is wider or
• The standard spark gap is 0.65 mm (0.026 in.).
narrower than the standard gap.
• Correct the spark gap if it is wider or narrower than the
• Fastening torque: 15 to 17 N·m
standard gap.
• Fastening torque:
FUEL FILTER
FUEL FILTER
• Check periodically.
• Check periodically.
• Do not allow dust to enter fuel tank.
• Do not allow dust to enter fuel tank.
• A clogged filter will cause difficulty in starting engine or
• A clogged filter will cause difficulty in starting
abnormalities in engine performance.
engine or abnormalities in engine performance.
• Pull the fuel filter out through fuel inlet port with a piece
• Pull the fuel filter out through fuel inlet port with a
of steel wire or the like.
piece of steel wire or the like.
• When the filter is dirty, replace it.
• When the filter is dirty, replace it.
• when the inside of the fuel tank is dirty, rinsing the tank
• When the inside of the fuel tank is dirty, rinsing
out with gasoline can clean it.
the tank out with gasoline can clean it.
OIL FILTER
OIL FILTER
• Check periodically.
• Check periodically.
• Do not allow dust to enter into oil tank.
• Do not allow dust to enter into oil tank.
• A clogged oil filter will affect the normal lubricating
• A clogged oil filter will affect the normal
system.
lubricating system.
• Pull it out through oil filling hole with a piece of steel
• Pull it out through oil filling hole with a piece of
wire or the like.
steel wire or the like.
• If the filter is dirty, wash it in gasoline or replace it.
• If the filter is dirty, wash it in gasoline or replace
• when the inside of the tank gets dirty, rinsing the tank
it.
out with gasoline can clean it.
• When the inside of the tank gets dirty, rinsing the
tank out with gasoline can clean it.
25
26
(130 to 145 in. lb.).
150 to 170 Kgf • cm
(130 to 145 in • lbf).
CS-400