Function Keys; Programming Security Codes - DSC New Classic PC585 User Manual

Function Keys

PK/RFK55XX and PC1555RKZ Keypads Only
These keypads have five function keys – marked Stay, Away, Chime, Reset and Exit – which
allow easy single-button activation of the most commonly used features. If these keys have
been enabled by your installer, you can execute the programmed function by pressing and
holding the corresponding key for two seconds. Corresponding function keys on the
PC1555RKZ are number keys 1 to 5 respectively.
For more information regarding the operation of the function keys, talk to your alarm system
installer.

Programming Security Codes

Programming codes from an LED Keypad:
The Master Code
To program the Master Code, enter [,][5][current Master Code][40][new Master Code]. The
Master Code must be four digits unless otherwise indicated by your installer. Enter digits 0
through 9 only. Press [#] to return to the Ready state.
Be sure to record your new Master Code in "System Information" on page 2.
NOTE: We recommend that the factory default or obvious codes such as [1111] or
[1234] not be used.
Additional Codes
Up to 32 additional access codes (01 through 32) may be programmed.
To program a new code:
Enter [,][5][Master Code][code number 01 to 32][new access code]. The code number is
a double digit from 01 to 32. Access codes must be four digits unless otherwise indicated
by your installer. Enter digits 0 through 9 only. Press [#] to return to the Ready state.
If an access code already exists for the code number you have selected, it will be replaced
by the new code. Be sure to record your new code(s) in "System Information" on page 2.
To erase a code:
Enter [,][5][Master Code][code number 01 to 32][,]. Press [#] to return to the Ready state.
The Master code cannot be erased.
Programming codes from a PK/RFK5500 or LCD Message Keypad:
Master Code
Press the [,] key to enter the function list. Scroll (< >) to...
Press (*) for <>
Access Codes
Enter Master
Access Code
(*) to Edit
User Code 40P
Enter New Code
1234
(*) to Edit
User Code 01P
Be sure to record your new Master Code in "System Information" on page 2.
NOTE: We recommend that the factory default Master Code [1234] or obvious codes
such as 1111 not be used.
Press [5] or [,]. The display will read...
Enter your current Master Code. The display will read...
"40P" represents the Master Code. Use the scroll keys (< >) to go
<>
to "40P". Press the [,] key to indicate that you wish to program the
Master Code. The display will read...
Enter the new Master Code. The Master Code must be four digits
unless otherwise indicated by your installer. Enter digits 0 through 9
<>
only. Once the new code is entered, the keypad will beep 3 times
and the display will read...
<>
Press [#] to exit the code programming function.
10