Table of Contents
Advertisement
ef
EDS7001F MILANO
If the stove was operating prior to servicing allow at least 10 minutes for light
bulbs and heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the
risk of electric shock or damage to persons.
TO REPLACE POWER CORD
1. Remove the stove pipe kit (if equipped).
2. Unscrew the two black knobs on the front of the unit by turning
counterclockwise.
3. Grasp onto the front door, gently lift up and pull the door off of the unit.
4. Remove the upper light bracket mounting screws from the top and remove
the light bracket assembly from the unit.
5. Locate the four cam locks on the side panels inside the upper corners of
the stove and turn with a large slot screwdriver so the triangle on the cam
lock is pointing up towards the top of the stove.
6. Grasp the top at both sides and gently pull to release the top.
7. Remove the four screws from the rear panel.
8. Locate the main on/off switch mounted on the rear panel and disconnect
the wiring connections noting their original locations.
9. Slide the rear panel up approximately three inches.
10. Locate and remove the wiring connections for the power cord.
11. With needle nose pliers grasp the power cord strain relief grommet from
inside the rear cover and push while twisting to remove.
12. Pull the old power cord out through the rear cover.
13. Install the new power cord through the hole in the rear cover and connect
all of the wiring connections in their original locations.
14. Install the power cord retaining grommet on the power cord and insert into
the hole in the rear cover.
15. Reassemble in the reverse order as above.
14
Advertisement
Table of Contents
