Table of Contents
Advertisement
ef
7001F MILANO
If the stove was operating prior to servicing allow at least 10 minutes for light
bulbs and heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the
risk of electric shock or damage to persons.
TO REPLACE THE HEATER ASSEMBLY
1. Do to the partial disassembly of the stove care must be taken not to
scratch any surfaces or damage any components during the repair.
2. Remove the stove pipe kit (if equipped).
3. Unscrew the two black knobs on the front of the unit by turning
counterclockwise.
4. Grasp onto the front door, gently lift up and pull the door off of the unit.
5. Remove the upper light bracket mounting screws from the top and remove
the light bracket assembly from the unit.
6. Locate the four cam locks on the side panels inside the upper corners of
the stove and turn with a large slot screwdriver so the triangle on the cam
lock is pointing up towards the top of the stove.
7. Grasp the top at both sides and gently pull to release the top.
8. Locate and remove the mirror by pulling it out of the slots being careful not
to bump or drop it.
9. Remove the four screws from the rear panel.
10. Locate the main on/off switch mounted on the rear panel and disconnect
the wiring connections noting their original locations.
11. Grasp the rounded side panels and pull straight up to remove both panels.
12. Locate and remove the two screws on the steel plate in front of the logset.
13. Slide the logset assembly out through the front of the stove and remove.
14. Locate and remove the two screws in front of the light bulbs, but behind
the flame rod/flame motor assembly.
15. Remove the flame rod/flame motor assembly thru the rear of the unit.
15
Advertisement
Table of Contents
