Operation - Dimplex DS2205 Service Manual

OPERATION

Figure 1
UNITS WITh ThERMOSTAT CONTROL
To access the manual controls go to the back of the Stove.
(Figure 1)
A . 3-Position Switch
The switch has two (2) ON positions marked with and
"Manual". The "Manual" position is for manual operation.
In this position the built-in remote control is by-passed.
The position is for operating the unit with the provided
remote control. When in position the unit is operated with
the On and Off buttons of the remote control.
When the switch is in the center position the unit is off.
b . heater On/Off Switch
The Heater On/Off Switch supplies power to the heater fan
and the heater element. When the switch is in the On posi-
tion the heater operates if the thermostat calls for heat.
C . heater Thermostat Control
To adjust the temperature to your individual requirements,
turn the thermostat control clockwise all the way to turn on
the heater. When the room reached the desired tempera-
ture, turn the thermostat knob counter clockwise until you
hear a click. Leave in this position to maintain the room
temperature at this setting. For additional heat, turn clock-
wise until you hear the click again and the heater will turn
on. To turn the heater off, switch the Heater On/Off switch
to the OFF position.
!
NOTE: When the heater is switched ON, the heater fan
will operate. The heater element may or may not be on,
depending on the thermostat control setting (See "Heater
Thermostat Control")
UNITS WITh TWO hEAT SWITChES
To access the controls open the front door of the Compact
Stove. (Figure 2)
Main On/Off Switch
The On/Off switch supplies power to all unit functions.
When this switch is in the On position the flame effect oper-
ates without heat.
A
b
Figure 2
C
Low heat Switch
The Low Heat Switch supplies power to the heater fan and
the heater element. When the switch is in the On position
the heater operates on Low.
high heat Switch
The High Heat Switch supplies power to the heater fan and
the heater element, when the switch is in the On position
the heater operates on high.
!
NOTE: The Low Heat Switch must also be in the On
position for the high heat setting to operate.
Resetting the Temperature Cutoff Switch
Should the heater overheat, an automatic cut out will turn
the heater off and it will not come back on without being
reset. It can be reset by switching the 3-Position Switch to
OFF and waiting 5 minutes before switching the unit back
on.
CAUTION: If you need to continuously reset the
heater, unplug the unit and call Dimplex North America
Limited at 1-800-668-6663.
Remote Control
Some models of this stove are supplied with a radio
frequency remote control. This remote control has a range
of approximately 50 feet (15.25 m), it does not have to be
pointed at the stove and can pass through most obstacles
(including walls). It is supplied with one of hundreds of
independent frequencies to prevent interference with other
units.
!
NOTE: Before attempting any operation with the
remote, pull the plastic insulator strip out from between
Figure 3
Off Button
Plastic
Strip
On
Button
Battery
Cover
3