Stove Installation; Operation - Dimplex EOSM-2007 Owner's Manual

NOTE
A 15amp, 120 volt outdoor GFI circuit is required. Additional appliances on the same circuit
may exceed the current rating of the circuit breaker.
WARNING
Ensure the power cord is not installed so that it is pinched or against a sharp edge and ensure
that the power cord is stored or secured to avoid tripping or snagging to reduce the risk of fire,
electric shock or injury to persons.
Construction and electrical outlet wiring must comply with local building codes and other
applicable regulations to reduce the risk of fire, electric shock and injury to persons.
Do not attempt to wire your own new outlets or circuits. To reduce the risk of fire, electric
shock or injury to persons, always use a licensed electrician.

STOVE INSTALLATION

1. Make sure the units MAIN ON/OFF and REPELLENT ON/OFF switches are in the OFF
position (refer to operating instruction section).
2. Install the transformer onto the unit.
3. Plug the unit into a 15Amp/120volt outdoor GFI outlet. If the cord does not reach, you
may use an extension cord with a minimum rating of 120 volts, 8 amps, 18 gauge and
approved for outdoor use.

OPERATION

To access the controls go to the back of the Stove.
A. MAIN ON/OFF SWITCH
The on/off switch supplies power to the flame function of the unit.
B. REPELLENT ON/OFF SWITCH
The on/off switch supplies power to the repellent dispenser function of the unit
Main ON/OFF Switch
Repellent
On/Off
Switch
Figure 2
3