Volvo V70 Owner's Manual page 258

1. Open the lid of the emergency puncture
repair kit.
2. Detach the decal for maximum permitted
speed and affix it to the steering wheel.
WARNING
The sealing fluid can irritate the skin. In the
case of contact with skin, wash away the
fluid with soap and water.
3. Check that the switch is in position 0 and
locate the cable and the air hose.
NOTE
Do not break the bottle seal. The seal is bro-
ken when the bottle is screwed in.
4. Unscrew the orange cap and unscrew the
bottle's stopper.
WARNING
Do not unscrew the bottle, it is equipped
with a reverse catch to prevent leakage.
5. Screw the bottle into its holder.
6. Unscrew the wheel's dust cap and screw
in the air hose valve connection to the bot-
tom of the thread on the tyre's air valve.
06 Maintenance and specifications
WARNING
Do not leave children in the car without
supervision when the engine is running.
7. Plug the cable into the 12 V socket and
start the car.
WARNING
Never stand next to the tyre when the com-
pressor is running. If cracks or unevenness
arise then the compressor must be
switched off immediately. The journey
should not be continued. Contact an
authorised tyre centre.
NOTE
When the compressor starts, the pressure
can increase up to 6 bar but the pressure
drops after approximately 30seconds.
8. Flick the switch to position I.
IMPORTANT
Risk of overheating. The compressor must
not run for more than 10 minutes.
9. Inflate the tyre for 7 minutes.
Wheels and tyres
WARNING
If the pressure is below 1.8 bar then the hole
in the tyre is too big. The journey should not
be continued. Contact an authorised tyre
centre.
10. Switch off the compressor to check the
pressure on the pressure gauge. Minimum
pressure is 1.8 bar and maximum is
3.5 bar.
11. Switch off the compressor and unplug the
cable from the 12 V socket.
12. Detach the hose from the tyre valve and fit
the valve cap.
13. As soon as possible, drive approximately
3 km at a maximum speed of 80 km/h so
that the sealing fluid can seal the tyre.
Inflating the tyres
The car's original tyres can be inflated by the
compressor.
1. The compressor must be switched off.
Make sure that the switch is in position 0
and locate the cable and air hose.
2. Unscrew the wheel's dust cap and screw
in the air hose valve connection to the bot-
tom of the thread on the tyre's air valve.
06
257