Volvo V70 Owner's Manual page 145

04 Comfort and driving pleasure
Audio system
•
Band III - over the whole country
•
LBand - mainly in large cities
By selecting for example
channel programming takes place more
quickly than if both Band III
selected. It is not certain that all channel
groups will be found. Wavelength selection
does not affect the stored memories.
Navigation via lists
There are three types of basic list which can be
04
used for navigation:
•
Ensemble list - Shows channel groups
that the receiver has obtained via channel
group programming.
•
Service list
- Shows channels irrespective
of the channel group to which they are allo-
cated. The list can also be filtered using
DAB-PTY (see below).
•
Subchannel list - Subchannels to a
selected channel.
The lists can be accessed via the menu. The
channel groups can also be accessed by
pressing ENTER.
Scanning (SCAN)
Scanning means that all channels in the list are
played for 10 seconds each.
Press SCAN to activate
144
Scanning can also be selected in DAB-PTY
mode. In which case only the preset type of
channels is played.
Band III on its own,
Stop scanning by pressing SCAN once, or
by pressing EXIT.
and LBand are
Subchannel
Secondary components are usually named
subchannels. These are temporary and can
contain e.g. translations of the main pro-
gramme into other languages.
If one or more subchannels are broadcast then
the > symbol is shown to the right of the chan-
nel name in the display. A subchannel is shown
by means of the
of the channel name in the display.
To access a subchannel:
Press
To navigate between subchannels:
Press
Subchannels can only be accessed on the
selected main channel and not on any other
one without selecting it.
DAB PTY (program type)
DAB PTY
gramme. There are 29 different programme
types which also include different programme
> symbol appearing to the left
or
selects one type of radio pro-
categories. After selecting a programme type,
navigation only takes place within the channels
broadcasting that type.
Exit this mode as follows:
Press EXIT
It is also possible to select a preset channel or
exit DAB-PTY via the menu. In certain cases
DAB radio will exit PTY mode when DAB to
DAB linking (see below) is implemented.
DAB to DAB link
It is possible to exit a channel with poor or no
reception to the same channel in another chan-
nel group with better reception. There may be
a certain delay when changing channel group.
There may be a short silence between the
availability of the current channel finishing to
the availability of the new channel starting.
DAB display settings
1. Basic - Only the channel name is shown if
a primary component is being played. A
subchannel name is shown if it is a sub-
channel being played
2. Ensemble mode
- Adds the channel
group name to the channel name
3. Ensemble + PTY - Adds the programme
type name under the channel name