Id Button; Camera Buttons; Sequence Button; Login/Logout Button - Speco D24GS Operation Instruction Manual

Operation Instruction
NOTE: For simplicity, the button descriptions in this manual refer to the front panel buttons.

ID Button

If a DVR System ID is set to 0, the infrared remote control will control that DVR without any additional operations.
(Refer to the System General setup screen in this chapter for further information on setting the System ID.) If the system
ID is 1 to 16, you must to press the
that DVR. If the System ID of two or more DVRs is set to 0, those DVRs will react to the infrared remote control at
the same time.

Camera Buttons

Pressing the individual camera buttons will cause the selected camera to display full screen. Buttons 1 to 9 are also
used to enter passwords.

Sequence Button

When in the Live Monitoring mode, pressing the

Login/Logout Button

Pressing the
LOGIN/OUT

Arrow Buttons

These buttons are used to navigate through menus and GUI. You can also use them to change numbers by highlighting
a number in the menu and using the Up and Down arrow buttons to increase or decrease the number's value. These
buttons are also used to control Pan and Tilt when in the PTZ mode.

Menu Button

In the Live Monitoring mode and Search mode, pressing the

Playback Buttons

 Rewind: Pressing the
speed from , and
 Play/Pause: Pressing the
The screen displays when the DVR is in the Pause mode and the screen displays when the DVR is playing back
video.
 Fast Forward: Pressing the
playback speed from
 Stop: Pressing the
 Backward: When in the pause mode, pressing the
 Forward: When in the pause mode, pressing the
In the Live Monitoring mode, pressing any playback button enters to the Search mode.

Alarm Button

Pressing the button resets the DVR's outputs including the internal buzzer during an alarm.
ALARM

Layout Button

Pressing the button toggles between different display formats. The available formats are: 4x4, 3x3 and 2x2.
LAYOUT
12
button and then press the number button (1 to 16 (+10 & 6)) in order to control
ID
SEQUENCE
button displays the Login or Logout screen.
button plays video backward at high speed. Pressing the button again toggles the playback
.
button plays back video at regular speed and pressing the button again pauses video.
button plays video forward at high speed. Pressing the button again toggles the
, and .
button stops playback and enters the Live Monitoring mode.
button displays live channels sequentially.
button displays the menu icons at the top of the screen.
MENU
button moves to the previous image.
button moves to the next image.