Front panel LEDs and connectors
Front panel LEDs and connectors
54
Figure 21: FortiSwitch-5003A front panel
Base Network
Activity LEDs
B1 B2
RJ-45 COM
Base 1G
Port
Copper
Retention
Screw
OOS
Healthy
Extraction
LED
LED
Lever
MGMT 1G
Active
Copper
LED
Interface
BASE 10G Optical
or Copper SFP
•
One front panel base backplane 10-gigabit optical or copper SFP+ interface
(BASE 10G) that connects to the base backplane channel
•
Eight front panel fabric backplane 10-gigabit optical or copper SFP+ interfaces
(14/F8, F7, F6, F5, F4, F3, F2, and F1)
•
One gigabit out of band management ethernet interface (MGMT)
•
One RJ-45, RS-232 serial console connection (COM)
•
Mounting hardware
•
LED status indicators
•
IEEE 802.1q VLANs
•
IEEE 802.3ad static mode layer-2 link aggregation
•
Link aggregation using a hash algorithm based on source and destination IP
addresses
•
Multi-Spanning Tree Protocol (MSTP) (IEEE 802.1s) to support redundant
FortiSwitch-5003A boards and external MSTP-compatible switches
•
Heartbeat between FortiGate-5001A and FortiGate-5005FA2 boards and the
FortiSwitch-5003A over the fabric channel to support MSTP (configurable from
the FortiGate-5001A and FortiGate-5005FA2 systems)
•
Standard FortiOS command line interface (CLI) for configuring fabric switch
settings (VLANs, MSTP, trunks, and so on)
From the FortiSwitch-5003A font panel you can view the status of the board LEDs
to verify that the board is functioning normally. The front panel includes a reset
switch for restarting the FortiSwitch-5003A board.
The front panel also contains connectors to the fabric and base channels, an out
of band management ethernet interface, and an RJ-45 RS-232 console port for
connecting to the FortiSwitch-5003A CLI.
Fabric Network
Activity LEDs
14/F8 F7 F6 F5 F4 F3 F2 F1
Fabric 10G Optical or Copper SFP
Fault
LED
Reset
Switch
FortiGate-5000 Series Introduction
FortiSwitch-5003A system
Retention
Screw
Hot Swap
Extraction
LED
Lever
01-30000-83466-20090108