Activating/Deactivating Collision Warning System - Ford 2011 Edge Owner's Manual

WARNING: The collision warning system's brake support can
only help reduce the speed at which a collision occurs if the
driver applies the vehicle's brakes. The brake pedal must be pressed
just like for any typical braking situation.
Blocked sensor
If a message regarding a blocked
sensor is displayed, the radar signals
from the sensor, located behind a
fascia cover near the driver side of
the lower grille, have been
obstructed. When the radar signals
are obstructed, a vehicle ahead
cannot be detected and the collision
warning system will not function.
The following table lists possible
causes and actions for this message being displayed.
Cause
The surface of the radar in
the grille is dirty or
obstructed in some way
The surface of the radar in
the grille is clean but the
message remains in the
display
Heavy rain, spray, snow, or
fog is interfering with the
radar signals
Swirling water, or snow or
ice on the surface of the
road may interfere with the
radar signals

Activating/deactivating collision warning system

To turn the warning system and/or chime on or off and set the warning
sensitivity <– –>, refer to Message center in the Instrument Cluster
chapter.
2011 Edge (edg)
Owners Guide, 1st Printing
USA (fus)
Action
Clean the grille surface in front of the
radar or remove the object causing the
obstruction
Wait a short time. It may take several
minutes for the radar to detect that it is
no longer obstructed
The collision warning system is
temporarily disabled. Collision warning
should automatically reactivate a short
time after the weather conditions
improve.
The collision warning system is
temporarily disabled. Collision warning
should automatically reactivate a short
time after the weather conditions
improve.
Driving
273