Panel Dimmer Control; Flash To Pass; Daytime Running Lamps - Ford 2010 Ranger Owner's Manual

Flash to pass

Pull toward you slightly to activate
and release to deactivate.
Daytime running lamps (DRL) (if equipped)
The daytime running light system turns the headlamps on with a
reduced light output.
To activate:
• the ignition must be in the on position and
• the headlamp system is in the off position or parking lamp position.
WARNING: Always remember to turn on your headlamps at
dusk or during inclement weather. The daytime running light
(DRL) system does not activate your tail lamps and generally may not
provide adequate lighting during these conditions. Failure to activate
your headlamps under these conditions may result in a collision.

PANEL DIMMER CONTROL

Use to adjust the brightness of the
instrument panel and all applicable
switches in the vehicle during
headlamp and parking lamp
operation.
Move the control up or down to
adjust the intensity of the panel
lighting.
Move the control to the full upright
position, past detent, to turn on the
interior lamps.
2010 Ranger (ran)
Owners Guide, 1st Printing
USA (fus)
Lights
45