AOpen AX4C Max II Online Manual page 101

A X 4 C M a x I I
A X 4 C M a x I I
Promise FastTrak 378 Windows 2000 Installation
*****************************
New Windows 2000 Installation
*****************************
The following details the installation of the FastTrak 378 drivers while installing Windows 2000.
1. Start the installation:
* Floppy Install: Boot the computer with the Windows 2000 installation diskettes.
* CD-ROM Install: Boot from the CD-ROM. Press F6 after the message "Press F6 if you need to install third party SCSI or
RAID driver" appears.
2. When the "Windows 2000 Setup" window is generated, press "S" to Specify an Additional Device(s)
3. Insert the Promise TechnologyO driver diskette into drive A: and press "Enter" key.
4. Choose "Win2000 Promise FastTrak 378 (tm) Controller" from the list that appears on screen, then press the "Enter" key.
5. Press Enter to continue with installation or if you need to specify any additional devices to be installed, do so at this time.
Once all devices are specified, Press Enter to continue with installation.
6. From the Windows 2000 Setup screen, press the Enter key. Setup will now load all device files and then continue the
Windows 2000 installation.
**********************************
Existing Windows 2000 Installation
**********************************
After installing the FastTrak 378 and rebooting your system, Windows 2000 setup will show a "Found New Hardware" dialog
101
O n l i n e M a n u a l
O n l i n e M a n u a l