Appendix; Adding Host Entries To The Netlinx Url List - AMX i!-PCLink/PowerPoint Instruction Manual

Appendix

Adding Host Entries to the NetLinx URL List

Follow these steps to add host entries to the NetLinx URL list:
1. Open a terminal session (via TELNET or SERIAL) to the NetLinx Master.
2. Type "echo on", and press the Enter button.
3. Type "url list", and press the Enter button.
If no URL's are in your NetLinx Master, it returns the following response:
No URLs in the URL connection list
4. To add a URL, type "set url", and press the Enter button.
The NetLinx Master should return:
Type A and Enter to Add a URL or Enter to exit. ->
5. Type "A", and press the Enter button.
The NetLinx Master should return:
Enter URL ->
6. This is where you enter the IP Address of the i!-PCLink/Media Player Host Computer.
Type "192.168.1.1", and press the Enter button. (Replace 192.168.1.1 with your IP Address).
The NetLinx Master should return:
192.168.1.1 (Your IP Address)
Enter Port or hit Enter to accept default (1319) ->
7. Press the Enter button to accept the default port (1319).
The NetLinx Master should return:
Enter Type (Enter for permanent or T for temporary) ->
8. Press the Enter button to make the entry permanent.
The NetLinx Master should return:
URL Added successfully.
Type A and Enter to Add a URL or Enter to exit. ->
9. Finally, Press the Enter button to exit.
10. To make sure the entry was made, or to check the status of the link, type "url list". Press the
Enter button. The NetLinx Master should return:
The following URLs exist in the URL connection list
->Entry 0-192.168.1.1:1319 IP=192.168.1.1 State=Issue Connect
The URL list can also be managed in NetLinx Studio, under "NetLinx Diagnostics"
i!-PCLinkPowerPoint
Appendix
19