Programming Chase Patterns: 2X8 And 8X8 Modes - Elation Stage Setter 8 User Instructions

Stage Setter 8™
Programming Chase Patterns:
You may create up to 8 Chase Patterns consisting of up to 32 steps
(scenes). These patterns are stored in to the Pattern Buttons (17).
To initiate programming, first tap the Program Button (14) so that the
Program to activate program mode, the program LED will glow when
program mode is activated. Once program mode is activated tap the
Pattern Button (17) you wish to program to. Once you selected a pat-
tern bank to store your program the corresponding pattern LED will
begin to flash indicating which Pattern Button (17) was selected. You
may now begin the program process.
Programming Chase Patterns (2x8 and 8X8 modes):
When in the 2x8 or 8x8 mode, each pattern can only be programmed
using Scene X Sliders (2), and each step will only includes Channels
1-8.
Example:
Programming a 32 step pattern into the Pattern 5 Bank Button using
the Scene X Sliders (2).
1. Tap the Program Button (4), the program LED will begin to glow.
2. Tap the Pattern 5 Button (17), the Pattern 5 LED will begin flashing.
3. Move the desired Scene X Sliders (17) to the levels desired as the
first step of this pattern.
4. Tap the Program Button (4) to program this step into memory, all
channel LED should flash once and the LCD (7) will read "01".
5. Repeat steps 3 and 4 until the LCD (7) reads "end." End will
denote the maximum of 32 steps has been reached.
6. After the maximum of 32 steps has been programmed, program
mode will automatically release.
7. If you wish to program less steps in to your program, you can exit
the program mode manually y by tapping on the Blackout
Button (15) once. This will manually release the program mode.
NOTE:
While in program mode, all other functions will lock.
Elation Professional - www.elationlighting.com - Stage Setter 8™ Instruction Manual Page 17
®
Basic Programming Stage Setter 8™
Programming Chase Patterns (1x16 mode):
When in the 1x16 mode, both the Scene X (1-9) and the Scene Y Chan-
nels (9-16) can be used.
Example:
Program a 4 step pattern with channels 7-10 at full in sequence in to
the Pattern 6 Button using both the Scene X (2) and Scene Y (11) slid-
ers.
1. Be sure you are in the 1x16 mode. If not, use the Mode
Button (3) to select 1x16 operation.
2. Tap the Program Button (4), the program LED will begin to
glow.
3. Tap the Pattern 5 Button (17), the Pattern 5 LED will begin
flashing.
4. Move all Scene X (2) and Scene Y (11) sliders to fully down.
5. Move Scene X slider 7 to the full intensity position.
6. Tap the Program Button (4) once, the LCD (7) will read "01".
7. Move Scene X slider 8 to the full intensity position.
8. Tap the Program button once, the LCD (7) will read "02".
9. Move Scene Y slider 9 to the full intensity position.
10. Tap the Program Button (4) once, the LCD (7) will read "03".
11. Move Scene Y slider 10 to the full intensity position.
12. Tap the Program Button (4) once, the LCD (7) will read "04".
13. Tap the Blackout Button (15) once to exit the program
mode, the Program LED (4) will turn off.
14. To test your program press the Pattern 6 Button. Your four
step chase pattern will begin to run.
Elation Professional - www.elationlighting.com - Stage Setter 8™ Instruction Manual Page 18
®
Basic Programming