Frt Panel Controls And Functions - Elation Stage Setter 8 User Instructions

Stage Setter 8™
XLR Male Socket
1 Ground
2 Cold
2 Cold
3 Hot
REMOTE
INPUT OUTPUT
SOUND CONTROL
INPUT
Special Note: Line Termination.
When longer runs of cable are used, you may need to use a terminator
POWER
on the last unit to avoid erratic behavior. A terminator is a 90-120 ohm
1/4 watt resistor which is connected between pins 2 and 3 of a male
XLR connector (DATA + and DATA -). This unit is inserted in the female
XLR connector of the last unit in your daisy chain to terminate the
line. Using a cable terminator will decrease the possibilities of erratic
behavior.
1
DMX512 IN
3 3
3-PIN XLR
2
Elation Professional - www.elationlighting.com - Stage Setter 8™ Instruction Manual Page 7
®
XLR Female Socket
XLR Pin Configuration
1 Ground
Pin 1 = Shield
Pin 2 = Data Compliment (negative)
3 Hot
Pin 3 = Data True (positive)
REMOTE
SOUND CONTROL
INPUT
Termination reduces signal errors and
avoids signal transmission problems
1
and interference. It is always advisable
2 to connect a DMX terminal, (Resistance
120 Ohm 1/4 W) between PIN 2 (DMX-)
and PIN 3 (DMX +) of the last fixture.
Figure 4
Set Up Stage Setter 8™
Front Panel
1
INPUT OUTPUT
Figure 3
POWER
9
Front Panel - Controls and Functions
1. Channel LEDs (1-8):
These 8 LEDs detail the current intensity for channel sliders 1-8. The
more you raise the channel slider the higher the output. The LED indi-
cators will directly reflect the changes in slider level.
2. Scene X - Channel Faders 1-8:
These 8 sliders are used to control the intensities of channel 1-8. The
overall intensity of channel faders 1-8 is controlled by the X Crossfader
(5).
Elation Profesional
Controls and Functions
2 3
10 11 12
- www.elationlighting.com - Stage Setter 8™ Instruction Manual Page 8
®
4 5 6 7 8
13 14 15 16 17