American DJ FREQ Matrix Quad User Instructions page 5

FREQ Matrix Quad
1. Press the MENU button until "SHND" is displayed, press
ENTER.
2. "SH X" will now be displayed. "X" representing a number
between 0-8. Shows 1-8 are preset shows, while "SH 0" is random
show. Press the UP or DOWN buttons to find your desired show.
3. Once you have found your desired show press ENTER, and
then press and hold the MENU button for at least 3 seconds to
confirm.
SOUN
- In this submenu you can activate sound active
mode.
1. Press the MENU button until "SOUN" is displayed, press
ENTER.
2. Either "ON" or "OFF" will now be displayed. Press the UP or
DOWN buttons to select one or the other.
3. When you have made your selection, press the ENTER, and
then press and hold the MENU button for at least 3 seconds to
confirm.
SENS -
Sound sensitivity control.
1. Press the MENU button until "SENS" is displayed, press ENTER.
2. The display will show a number between 0-100. Press the UP or
DOWN buttons to adjust the sound sensitivity. 0 being the least sensi-
tive and 100 the most sensitive.
3. Press the ENTER, and then press and hold the MENU button for at
least 3 seconds to confirm.
DNST
- This mode can be used as a precaution mode, that
in case the DMX signal is lost, the operating mode chosen in
the setup is the running mode the fixture will go into when
the DMX signal is lost. You can also set this as the operat-
ADJ Products, LLC - www.adj.com - FREQ Matrix Quad Instruction Manual Page 9
System Menu FREQ Matrix Quad
ing mode you would like the unit to return to when power is
applied.
1. Press the MENU button until "DNST" is displayed, press
ENTER.
2. Either "MASL", "BLND", or "LAST" will be displayed. Choose
an operating mode you would like the unit to start up in when
power is applied or the DMX signal is lost.
• MASL (Master Slave) - If the DMX signal is lost or power is
applied, the unit will automatically go into Master Slave mode.
• BLND (Blackout) - If the DMX signal is lost or power is applied,
the unit will automatically go into stand by mode.
• LAST (Last State) - If the DMX signal is lost the fixture will stay
in the last DMX set up. If power is applied and this mode is set,
the unit will automatically go into the last DMX set up.
3. Press ENTER to confirm your desired set up.
LED
2 minutes.
1. Press the MENU button until "LED" is displayed, press ENTER.
2. Either "ON" or "OFF" will now be displayed. Press the UP or
DOWN buttons to select "ON" to keep the LED display on at all
times, or "OFF" to allow the LED display to turn off after 2 min-
utes. Press any button to turn the LED display on again.
3. Press ENTER to confirm your selection.
DISP
1. Press the MENU button until "DISP" is displayed, press
ENTER.
2. When "DISP" is displayed the LED display will remain normal,
ADJ Products, LLC - www.adj.com - FREQ Matrix Quad Instruction Manual Page 10
- With this function the LED display will turn off after
- This will "flip" the LED display
System Menu