Advertisement

American DJ
User Instructions
®
American DJ
4295 Charter Street
Los Angeles Ca. 90058
www.americandj.com
FAB 4™
Introduction:
Congratulations and thank you for purchasing the
FAB 4™ by American DJ
. You have just purchased one of the most
®
innovative and reliable lighting systems on the market today! This
system includes four units, a master and three slaves. This system was
designed to give you an instant high power light show with the sim-
plest set-up procedures possible. This system is expandable and DMX
compatible. Please read and understand the instructions in this manual
carefully and thoroughly before attempting to operate this unit. These
instructions contain important information regarding safety during use
and maintenance.

Customer Support:

American DJ
support line, to provide set up and installation help and to answer any
question should you encounter problems during your set up or initial
operation. You may also visit us on the web at www.americandj.com
for any comments or suggestions. Toll free customer service hours are
Monday through Friday 9:00 a.m. to 5:00 p.m. Pacific Standard Time.
Voice:
(800) 322-6337
Fax:
(323) 582-2610
E-mail:
support@americandj.com
Warning!
To prevent or reduce the risk of electrical shock or fire, do
not expose this unit to rain or moisture.
Caution!
There are no user serviceable parts inside this unit. Do not
attempt any type of repair yourself without the manufactures consent,
doing so will void your manufactures warranty. In the unlikely event your
unit may require service please contact American DJ
port.
HALOGEN LAMP WARNING!
This fixture is fitted with a halogen lamp which is highly susceptible to
damage if improperly handled. Never touch the lamp with your bare
fingers as the oil from your hands will shorten the lamp life. Never
install, mount, or place this fixture in areas prone to heavy vibration.
Also, never move the fixture until the lamp has had ample time to cool.
Remember, lamps are not covered under warranty conditions.
American DJ Supply
- www.americandj.com - FAB 4™ Instruction Manual Page 2
©
®
Introduction
provides a toll free customer
®
customer sup-
®

Advertisement

Table of Contents
loading

Summary of Contents for American DJ FAB 4

  • Page 1: Customer Support

    There are no user serviceable parts inside this unit. Do not attempt any type of repair yourself without the manufactures consent, doing so will void your manufactures warranty. In the unlikely event your unit may require service please contact American DJ customer sup- ®...
  • Page 2: Table Of Contents

    C. The appliance has been exposed to rain or water. D. The appliance does not appear to operate normally or exhibits a marked change in performance. American DJ Supply www.americandj.com FAB 4™ Instruction Manual Page 4 American DJ Supply www.americandj.com FAB 4™ Instruction Manual Page 3 ©...
  • Page 3: Set-Up

    Before plugging your unit in, be sure the source volt- Special Note: Line Termination. When longer runs of cable are age in your area matches the required voltage for your American DJ used, you may need to use a terminator on the last unit to avoid erratic ®...
  • Page 4: Controls & Functions

    Always replace with the exact same type fuse, unless other- To DMX Controller Output wise instructed to do so by an authorized American DJ service tech- nician. 10. Power Cord - Connect only to a matching power outlet. Never use this fixture if the ground prong has been removed or broken off.
  • Page 5 8-unit system. 1 2 3 4 5 6 7 8 9 10 DMX Cable Line American DJ Supply - www.americandj.com - FAB 4™ Instruction Manual Page 9 American DJ Supply - www.americandj.com - FAB 4™ Instruction Manual Page 10 ©...
  • Page 6: Lamp Replacement

    Master - Head 1 Slave - Head 2 Retaining thumb screws American DJ Supply - www.americandj.com - FAB 4™ Instruction Manual Page 12 American DJ Supply - www.americandj.com - FAB 4™ Instruction Manual Page 11 ©...
  • Page 7: Dip Switch Charts

    HEADS 2 & 3 ON parts at its expense, and will absorb all expenses for warranty service and repair labor by the DMX value to reach your desired reason of defects in material or workmanship. The sole responsibility of American DJ under ®...
  • Page 8 Please Note: Specifications and improvements in the design of this unit and this manual are subject to change without any prior written notice. ©American DJ Supply American DJ World Headquarters: 4295 Charter Street Los Angeles, CA. 90058-2520 USA Tel: 323-582-2650 Fax: 323-582-2610 Web: www.americandj.com E-mail: info@americandj.com American DJ Supply - www.americandj.com - FAB 4™...

Table of Contents