American DJ Accu Spot 300 User Instructions page 12

Accu Spot 300
7. Press MODE/ESC to return to the main menu.
FLIP -
This function will reverse the display 180º.
1. Access the main menu.
2. Tap the UP button until "DISP" is displayed.
3. Press ENTER, the display will show "ON/OFF".
4. Press the UP button to select "ON" to activate this function,
or "OFF" to deactivate this function.
5. Press ENTER to confirm.
6. Press MODE/ESC to return to the main menu.
SPEC MAIN MENU -
RDMX
With this function you are able to change the DMX
address via any DMX controller. This function is factory set
to "ON" already.
1. Access the main menu by pressing MODE/ESC.
2. Tap the UP button until "SPEC" is displayed, press ENTER.
3. Tap the UP button until "RDNX" is displayed, press ENTER.
4. The display will show "ON/OFF". Press the UP button to
select "ON" to activate this function, or "OFF" to deactivate.
5. Press ENTER to confirm, and "PASS" will flash quickly.
6. Press MODE/ESC to return to the main menu.
To use this function follow the instructions:
To adjust the address of your unit you must first go to the
address that it is currently set to. From there you can adjust the
address. First make sure all channels are set to the value of "0".
1. On your DMX controller set the DMX value of Channel 1 to
the value "7".
American DJ - www.americandj.com - Accu Spot 300 Instruction Manual Page 23
®
System Menu Accu Spot 300
2. Now set the DMX value of Channel 2 to the value "7" to
adjust the starting address between 1 and 255. To adjust the
address between 256 and 511 set Channel 2 to the value "8" .
3. Set the DMX value of Channel 3 to your desired start-
ing address. This will take about 20 seconds before the unit
accepts the new DMX address.
EXAMPLE: So, if you want the address to be 57, you must first
set the address that is currently assingned to the unit. The pro-
ceed to set Channel 1s' value to "7", Channel 2s' value to "7",
and Channel 3s' value to "57".
2ND EXAMPLE: Again, if you want the address to be 420, you
must first set the address that is currently assingned to the unit.
If you want the set the address to 420, set Channel 1s' value to
"7", Channel 2s' value to "8", and Channel 3s to "164". (256 +
164 = 420)
SPOT
the control board. The shutter opens and the lamp can be
adjusted. In this mode, the device will not react to any con-
trol signal.
1. Access the main menu.
2. Tap the UP button until "SPEC" is displayed, press ENTER.
3. Tap the UP button until "SPOT" is displayed, press ENTER.
4. The display will show "ON/OFF".
5. Press the UP button to select "ON" to activate this function,
or "OFF" to deactivate this function.
6. Press ENTER to confirm.
7. Press MODE/ESC to return to the main menu.
DFSE
American DJ
- With this function you can adjust the lamp via
- With this function you can restore the factory
- www.americandj.com - Accu Spot 300 Instruction Manual Page 24
®
System Menu