American DJ ScanTron 250 User Instructions

American DJ ScanTron 250 User Instructions

Five channel dmx intelligent scanner

Advertisement

American DJ
User Instructions
Rev. 5/07
®
American DJ
®
4295 Charter Street
Los Angeles CA. 90058
www.americandj.com
ScanTron 250™
Unpacking:
Thank you for purchasing the ScanTron 250™ by Ameri-
can DJ
. Every ScanTron 250™ has been thoroughly tested and has
®
been shipped in perfect operating condition. Carefully check the ship-
ping carton for damage that may have occurred during shipping. If the
carton appears to be damaged, carefully inspect your fixture for any
damage and be sure all equipment necessary to operate the unit has
arrived intact. In the event damage has been found or parts are miss-
ing, please contact our toll free customer support number for further
instructions. Please do not return this unit to your dealer without first
contacting customer support.
Introduction:
This unit is five channel DMX intelligent scanner that
may be easily converted to an intelligent color changer by removing
the mirror unit. This unit can also run as a stand alone, sound-active
unit, or in a Master/Slave configuration as either a scanner or color
changer. The ScanTron 250
is best used in multiples of four. When used as a stand alone unit
or when used in multiples linked in a master/slave configuration the
optional Mini/C or Wireless/C controller may be used. The optional
controller will access different programs and control a blackout func-
tion. For best results use fog or special effects smoke to enhance the
beams projections.
Customer Support:
American DJ
port line, to provide set up help and to answer any question should you
encounter problems during your set up or initial operation. You may
also visit us on the web at www.americandj.com for any comments or
suggestions. Service Hours are Monday through Friday 9:00 a.m. to
5:00 p.m. Pacific Standard Time.
Voice:
(800) 322-6337
Fax:
(323) 582-2941
E-mail:
support@americandj.com
To purchase parts online visit http://parts.americandj.com
Warning!
To prevent or reduce the risk of electrical shock or fire, do
not expose this unit to rain or moisture.
Caution!
There are no user serviceable parts inside this unit. Do not
attempt any repairs yourself, doing so will void your manufactures war-
ranty. In the unlikely event your unit may require service please contact
American DJ
.
®
American DJ
- www.americandj.com - ScanTron 250™ Instruction Manual Page 2
©
®
General Information
comes with three built in programs and
provides a toll free customer sup-
®

Advertisement

Table of Contents
loading

Summary of Contents for American DJ ScanTron 250

  • Page 1 Thank you for purchasing the ScanTron 250™ by Ameri- ® can DJ . Every ScanTron 250™ has been thoroughly tested and has ® been shipped in perfect operating condition. Carefully check the ship- ping carton for damage that may have occurred during shipping. If the...
  • Page 2 Product Registration frayed or broken. The ScanTron 250™ carries a one year limited warranty. Please fill • Do not attempt to remove or break off the ground prong from out the enclosed warranty card to validate your purchase. All returned the electrical cord.
  • Page 3: Controls And Functions

    8. XLR Output Jack - This jack is used to transmit the incoming DMX signal to another DMX fixture, or transmit a Master/Slave signal to the nest ScanTron 250™ in the chain. For best results in DMX or Master/Slave mode terminate this jack if it is the last unit in the chain.
  • Page 4: Operation

    1. Using standard XLR microphone cables, daisy chain your units 1. The ScanTron 250™ uses five DMX channels. Channel 1 con- together via the XLR connector on the rear of the units. Remem-...
  • Page 5 The ScanTron 250™ is a five channel DMX unit. The DMX address Porgram 2 : Small Angle Program Function is set on the bottom panel of the ScanTron 250. ™ Your unit and your Porgram 3 : Free Angle Program Function DMX controller require a standard 3-pin XLR con- nector for data input and data output (Figure 1).
  • Page 6 120 Ohm 1/4 W) between PIN 2 (DMX-) and PIN 3 (DMX +) of the last fixture. Figure 4 American DJ - www.americandj.com - ScanTron 250™ Instruction Manual Page 11 American DJ - www.americandj.com - ScanTron 250™ Instruction Manual Page 12 ©...
  • Page 7 GOBO SPOT SHAKE 104 - 111 GOBO 1 SHAKE 112 - 119 GOBO 2 SHAKE American DJ - www.americandj.com - ScanTron 250™ Instruction Manual Page 13 American DJ - www.americandj.com - ScanTron 250™ Instruction Manual Page 14 © ® ©...
  • Page 8: Troubleshooting

    American DJ - www.americandj.com - ScanTron 250™ Instruction Manual Page 15 American DJ - www.americandj.com - ScanTron 250™ Instruction Manual Page 16 ©...
  • Page 9: Warranty

    ® tive parts at its expense, and will absorb all expenses for warranty service and repair labor by reason of defects in material or workmanship. The sole responsibility of American DJ ® Mirror under this warranty shall be limited to the repair of the product, or replacement thereof,...
  • Page 10: Specifications

    American DJ ® American DJ World Headquarters: 4295 Charter Street Los Angeles, CA 90058 USA Tel: 323-582-2650 / Fax: 323-582-2610 Web: www.americandj.com / E-mail: info@americandj.com American DJ - www.americandj.com - ScanTron 250™ Instruction Manual Page 19 © ®...

Table of Contents