Alcatel-Lucent OmniAccess 700 (Vers. 2.2, 2.2-R02, 2.3) Getting Started Manual page 20

Step 12: Enable HTTP & HTTPS for web-based management.
•
HTTP is the primary protocol used to transfer files over the World Wide Web. You
can access the OA-700 using HTTP through a web browser after being
authenticated.
http {enable|disable}
Example:
ALU(config)# http enable
•
HTTPS, in addition to the normal HTTP uses SSL encryption for secure
transmission of files.
Example:
ALU(config)# https enable
Note: SSH and HTTPS are not supported in the no crypto image. For information on the no
crypto release, refer to the release note.
Step 13: Enable Modem for Out of Band Management.
modem {enable|disable}
Example:
ALU(config)# modem enable
Step 14: Show Chassis - The 'show chassis' command provides a physical
inventory of the running chassis components for a specific slot or for the entire
system.
Example:
The following is an example of the show chassis command on an OmniAccess
740 system:
ALU> show chassis
Physical inventory at Thu Dec 11 08:48:30 2008
System started approximately Thu Dec 11 08:37:56 2008
Uptime is 0 days 0 hours 12 minutes 50 seconds
L2 - 8-port copper GigE (active)
Slot number: 1
Part number: 83000019
Manufacturer:
Description: 8-port copper GigE
Serial number:
Version: 01
Revision: A00
LoL firmware version: 2.2.68
Loader version: 2.33
ALU-OS version: 2.3.1.30
MDC
SE - Services engine (active)
Slot number: 3
OmniAccess 700 Getting Started Guide
Beta
ALU
DD0520001606
Serial number: WL0544000297
Revision: A00
Version: 01
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Performing Basic Configuration Tasks
15
Beta