Alcatel-Lucent OmniAccess 700 (Vers. 2.2, 2.2-R02, 2.3) Getting Started Manual page 19

Left running head:
Chapter name (automatic)
Performing Basic Configuration Tasks
Step 8: Configuring an interface. Enter the following command to enter the
Interface Configuration mode:
interface <name> <slot/port>
Example:
ALU(config)# interface GigabitEthernet 7/0
ALU(config-interfaceGigabitEthernet7/0)#
(For more information on configuring interfaces, refer to the 'The Command Line
Interface' chapter in the OmniAccess 700 CLI Configuration Guide.)
Step 9: Administratively bring up the interface by using the 'no shutdown'
command.
Example:
ALU(config-if GigabitEthernet7/0)# no shutdown
Step 10: Configure an IP address for the interface by entering the following
command. Enter the IP address in the valid IP address format A.B.C.D.
ip address {<ip-address subnet-mask>|<ip-address/prefix-
length>}
Example:
ALU(config-if GigabitEthernet7/0)# ip address 192.168.1.1/24
Note: In the above example, 192.168.1.1 is assumed to be the GigE 7/0 LAN facing
interface and IP address. You can configure the IP address based on your topology.
Step 11: Enable SSH and Telnet for in-band Management. The following
command enables SSH/Telnet connection to a remote computer:
•
Secure Shell (ssh) is a program for logging in to a remote machine that provides
secure communication between two systems.
ssh {enable|disable}
Example:
ALU(config)# ssh enable
•
Telnet is a user command and an underlying TCP/IP protocol for accessing
remote computers. Telnet is a program that enables connection to foreign or
remote host computers, and provides access to information on them.
telnet {enable|disable}
Example:
ALU(config)# telnet enable
14
Beta
Alcatel-Lucent
OmniAccess 700 Getting Started Guide
Beta