Turning Timer On And Off; Using The Sleep Timer - Onkyo CR-245DAB Instruction Manual

Using the Timer —Continued
Tips:
• If you decide to cancel during this procedure without
making timer settings, press the [TIMER] button.
• By pressing the [DISPLAY] button when specifying
the time, you can switch between 12-hour and 24-hour
displays.
Notes:
• Be sure to set the CD receiver to Standby, otherwise
the timed operation will not work.
If the timer has been set, timed operation will work
even if the SLEEP timer caused the CD receiver to
enter Standby mode.
Once the timer has been turned on, playback will start
at the same time every day. Be sure to turn off the
timer before leaving on vacation.
• If the timer turns the power on, the "SLEEP"
indication will light. If no operation is performed for
one hour, the CD receiver will automatically enter
Standby mode. If you perform any operation, the
"SLEEP" indication will turn off, and the CD receiver
will continue operating.

Turning Timer On and Off

Once a timer has been programmed, you can turn it on or
off as necessary. For example, while you're on holiday,
you may want to turn off the timer you use as an early
morning alarm.
TIMER
F/H
1 Press the [TIMER] button repeatedly until
"Timer On" or "Timer Off" appears.
2 Use the arrow []/[] buttons to select
either "Timer On" (set) or "Timer Off"
(cancel), and then press the [ENTER]
button.
If there is no operation for several seconds, the
setting will be made with the currently-shown
content, and the display will return to its previous
state.
If you specify Timer On (set), the "TIMER"
indication and the number of the selected input
source will light.
If you select Timer Off (i.e., turn off the timer), the
"TIMER" indicator will disappear.

Using the Sleep Timer

With the sleep timer, you can set the CD receiver so that
it automatically turns off after a specified period.
Press the [SLEEP] button repeatedly to select
the required sleep time.
With the [SLEEP] button, you can set the sleep time
from 90 to 10 minutes in 10 minute steps.
When the sleep timer has been set, the SLEEP indicator
appears on the display. The sleep time appears on the
display for about 3 seconds, then the previous display
reappears.
Checking the Remaining Sleep Time
To check the remaining sleep time, press the [SLEEP]
button.
Note that if you press the [SLEEP] button while the sleep
time is being displayed, you'll shorten the sleep time by
10 minutes.
For example if you press the [SLEEP] button and the
remaining time is shown as 55 minutes, pressing the
[SLEEP] button once again will shorten this time to 50,
SLEEP
and each subsequent press will shorten the time in 10
minute increments.
Canceling the Sleep Timer
To cancel the sleep timer, press the [SLEEP] button
repeatedly until "Sleep Off" appears.
Note:
• If the timer turns the power on, the "SLEEP"
indication will light. If you perform any operation, the
"SLEEP" indication will turn off. If you want to set
the SLEEP timer, you'll need to make the setting again
after the "SLEEP" indication turns off.
33
En-