Onkyo CBX-100 Instruction Manual page 12

CBX-100_En.book Page 12 Friday, September 15, 2006 9:34 AM
Getting to Know the CBX-100 —Continued
Replacing the Battery
Use only a battery of the same type (CR 2025, lithium
button battery).
1
While pushing the locking tab toward the
center of the remote controller, slide out
the battery holder.
2 Remove the old battery from the battery
holder, insert the new battery, and then
slide the battery holder back into the
remote controller.
Battery holder
Battery type
Locking tab
Notes:
• If the remote controller doesn't work reliably, try
replacing the battery.
• If you intend not to use the remote controller for a long
time, remove the battery to prevent damage from leak-
age or corrosion.
• An expired battery should be removed as soon as pos-
sible to prevent damage from leakage or corrosion.
Caution: Replacing the battery incorrectly may cause an
explosion. Use only a battery of the same type or an
equivalent.
12
Back of remote
controller
Locking tab
Positive (+) side up
Polarity (+) symbol
Aiming the Remote Controller
When using the remote controller, point it toward the
CBX-100's remote control sensor, as shown below.
Remote control sensor
30°
30°
Notes:
• The remote controller may not work reliably if the
CBX-100 is subjected to bright light, such as direct
sunlight or inverter-type fluorescent lights. Keep this
in mind when installing.
• If another remote controller of the same type is used
in the same room, or the CBX-100 is installed close to
equipment that uses infrared rays, the remote control-
ler may not work reliably.
• Don't put anything, such as a book, on the remote con-
troller because the buttons may be pressed inadvert-
ently, thereby draining the batteries.
• The remote controller will not work if there's an
obstacle between it and the CBX-100's remote control
sensor.
CBX-100