Before Using The Cd/Hdd Receiver; Installing The Batteries; Using The Remote Controller - Onkyo BR-925UKD Instruction Manual

Before Using the CD/HDD Receiver

Installing the Batteries

1 Detach the battery cover by pressing the
tab and pulling up the cover.
2
Insert two batteries (R6/AA) into the bat-
tery compartment.
Carefully follow the polarity diagram (positive
(+) and negative (–) symbols) inside the battery
compartment.
3
After the batteries are installed and
seated correctly, attach the compartment
cover.
Notes:
• If the remote controller doesn't work reliably, try replac-
ing the batteries.
• Don't mix new and old batteries or different types of bat-
teries.
• If you intend not to use the remote controller for a long
time, remove the batteries to prevent damage from leak-
age or corrosion.
• Expired batteries should be removed as soon as possible
to prevent damage from leakage or corrosion.
• When replacing the batteries, use R6/AA batteries.
Onkyo recommend that you use manganese dry batteries.
• If rechargeable batteries are used, the remote controller
may be inoperable.
6

Using the Remote Controller

When you operate the remote controller, point it at the
CD/HDD receiver's remote control sensor, as shown
below.
Remote control sensor
Notes:
• The remote controller may not work reliably if the CD/
HDD receiver is subjected to bright light, such as direct
sunlight or inverter-type fluorescent lights. Keep this in
mind when installing.
• If another remote controller of the same type is used in
the same room, or the CD/HDD receiver is installed close
to equipment that uses infrared rays, the remote control-
ler may not work reliably.
• Don't put anything, such as a book, on the remote con-
troller because the buttons may be pressed inadvertently,
thereby draining the batteries.
• The remote controller may not work reliably if the CD/
HDD receiver is installed in a rack behind colored glass
doors. Keep this in mind when installing.
• The remote controller will not work if there's an obstacle
between it and the CD/HDD receiver's remote control
sensor.
CD/HDD receiver