Programming The Timers - Onkyo CR-435UKD Instruction Manual

Using the Timers—Continued

Programming the Timers

Notes:
• You must set the clock before you can program the tim-
ers.
• Before programming a timer to turn on the radio, you
must preset the station you want to use. (See pages 41 and
42.)
• If you don't operate any buttons for 60 seconds while pro-
gramming a timer, the procedure will be cancelled and
the previous display will reappear.
STANDBY/ON
Number buttons
/
1 Press the [TIMER] button repeat-
edly to select Timer 1, 2, 3, or 4,
and then press [ENTER].
If "Clock" appears, you need to set the
clock (see pages 23, 47, and 48).
2
Use the Previous and Next [
[
"Rec", and then press [ENTER].
If you can't select "Rec", make sure that
your Onkyo cassette deck or MD
recorder is properly connected to the
MD/TAPE jacks (see pages 20 and 21)
and the Input Display is set accordingly
(see page 26).
50
TIMER
ENTER
] buttons to select "Play" or
or
3
Use the Previous and Next [
[
and then press [ENTER].
You can select the following sources:
If you selected "Rec", only "FM", "AM"
or "DAB" can be selected as the source.
4
If you selected "AM", "FM" or
"DAB", use the Previous and Next
[
radio preset, and then press
[ENTER].
5
If you selected "Rec", make sure
the name of the connected
recorder is flashing on the display,
and then press [ENTER].
6
Use the Previous and Next [
[
]/
"Every", and then press [ENTER].
Select "Once" for on-off operation.
Select "Every" to perform the same oper-
ation every week.
7
If you selected "Once", use the
Previous and Next [
buttons to select the day, and then
press [ENTER].
You can select: SUN, MON, TUE, WED,
THU, FRI, or SAT.
Go to step 10.
] buttons to select the source,
FM, AM, TAPE, DOCK, CD or
DAB.
]/[ ] buttons to select the
] buttons to select "Once" or
]/[
]/
]/
]