Changing The Input Display - Onkyo CR-435UKD Instruction Manual

Basic Operations—Continued

Changing the Input Display

You can choose what name is displayed when an input source is selected so that it matches the type of component that
you've connected to the MD/TAPE IN. When you connect an Onkyo
select the input source name that matches the type of component for
MENU/NO
/
1
Use the INPUT [
to select "TAPE".
2 Press and hold the [MENU/NO]
button until "Name Select?"
appears on the display, and then
press [ENTER].
HOLD
3
Use the Previous or Next
[
new input source name.
The input source names are selected in
the following orders:
TAPE
*
26
INPUT
/
ENTER
]/[ ] buttons
]/[ ] button to select the
MD
*
DAT
When you select an input source name, you
cannot select it as the recording component
at the set timer recording.
4
Input Source Name Abbreviations
Sometimes the input source name may be displayed as a
2-letter abbreviation, as per the following table.
Full name
*
VIDEO
-capable component, it's important that you
to work properly.
Press [ENTER] to confirm your
selection.
"Complete" appears on the display.
Abbreviation
DAT
MD
TAPE
VIDEO
DT
MD
TP
VD