Make A Custom-Made Bag With Foodsaver Rolls - FoodSaver Vac 1200 18-0163 User Manual

T H E F O O D S AV E R U S E R M A N U A L
How to Make a Custom-Made Bag with FoodSaver Rolls
When using FoodSaver Rolls you first need to make a bag. If you
are using ready-made FoodSaver Bags, go to page 10.
Place the appliance on a flat, dry surface and plug the power cord
1
into a standard electrical outlet.
Set the Sealing Time Adjustment Switch to "2."
2
Lay the item(s) you want to vacuum package near the FoodSaver
3
Roll so you can see where to cut the bag material. IMPORTANT:
Leave at least 3 extra inches at one end of the bag. Leave more
(one inch per reseal) if you plan to reuse the bag.
Cut the FoodSaver Roll to the desired length, making sure you
4
cut straight. The marks on the side of the roll are at 3 inch intervals
and will assist you in cutting straight.
Open the lid of the appliance.
5
Place one end of the bag on the Sealing Strip. Do not let the bag
6
slip into the Vacuum Channel.
IMPORTANT: Make sure the end of the bag does not go over the
black foam rubber ring, or into the Vacuum Channel.
8
T H E F O O D S AV E R U S E R M A N U A L
Close the lid.
7
Press on the lid with the palms
8
of your hands then release. The
solid green light will turn on.
When the green light goes off, the sealing process is complete.
9
Open the lid and remove the bag.
NOTE: Let the appliance cool down for at least 20 seconds before
using it again.
9