Connections; Connection To The Tv - Onkyo BD-SP807 Instruction Manual

Connection to the TV

• Make one of the following connections, depending on the capabilities of your existing device.
AUDIO CONNECTION
analogue audio
TV
AUDIO IN
R
RCA audio
cable
this unit
AUDIO OUTPUT
(DOWN MIX L/R)
*1)
This unit is compatible with the progressive scan system. The feature provides you with the higher quality pictures than traditional
output system does. To utilise this feature, a component or an HDMI connection is required. Refer to "HDMI Video Resolution" or
"Component Output" setting on page 39 to set the video resolution.
*2)
Analogue audio connection is not required for this connection.
Supplied cables used in this connection are as follows:
• RCA audio cable (L/R) x 1
• RCA video cable x 1
Please purchase the rest of the necessary cables at your local store.
Note
• Connect this unit directly to the TV. If the RCA audio / video cables are connected to a VCR, pictures may be
distorted due to the copy-protection system.
• If the picture is not output properly to the TV because of "HDMI Video Resolution" or "Component Output" setting,
press and hold [B (play)] on the front panel for more than 5 seconds. "HDMI Video Resolution" and "Component
Output" setting will be reset to the default automatically. You cannot change the video resolution during Blu-ray
Disc playback. To change the resolution, stop playback.
• A simple 1-cable connection with a device having an HDMI (high-definition multimedia interface) jack allows digital
transfer of both digital video signals and multi-channel audio signals.
EN

CONNECTIONS

Method 1
standard picture
VIDEO
L IN
and
VIDEO OUTPUT
(VIDEO)
VIDEO CONNECTION
Method 2
better picture
COMPONENT
VIDEO IN
Y
(Green)
P /C (Blue)
B B
P /C
R R (Red)
RCA
video
cable
RCA
or
component
video cable
(Red) (Blue)
VIDEO OUTPUT
(COMPONENT)
AUDIO/VIDEO
CONNECTION
*1
Method 3
best audio/picture
HDMI IN
HDMI
cable
or
(Green)
HDMI OUT
*1, 2
13